Calibration Services and Repair
MKS UK Capabilities & Resources
Pressure
-
Pressure calibration bench for Baratron calibration from 50 mT to 1000T full
scale using three 0.05% rdg transfer standard Baratrons.
-
Pressure calibration cart (PVS6) for general purpose Baratron calibration from
1Torr to 10,000 Torr full scale using 0.05% rdg transfer standard Baratrons.
-
Four pressure sets are maintained (a total of twelve transfer standard
Baratrons) to ensure full pressure calibration capability throughout the year.
-
Very large stock of spares for pressure products including spare sensors for
most process Baratrons.
Mass Flow
-
Primary gas flow calibrator using pressure rate of rise (ROR) technique for
re-certification of internal standards and calibration of customers equipment,
covering gas flows from 10 sccm to 20,000 sccm, accuracy 0.5% rdg.
-
Ten transfer standard mass flow controllers covering gas flow from 10 sccm to
200,000 sccm, with an accuracy of 0.8% FS.
-
Re-range, re-seal and re-scale of MFC's to all ranges above and to any gas
specified.
-
Very large stock of spares for Flow products including all mechanical
assemblies and parts to enable full rebuilds.
-
Leak detection capability to better than 10-10 mbar Ls-1 of
He.
Electronic Controllers
-
Full repair facility for all electronic controllers, power supply/readouts and
signal conditioning equipment.
-
National standard calibrated high accuracy multimeters and calibrators (three
6.5 digit DVM'S).
-
Large stock of spare parts to facilitate repairs.
Valves
-
Full repair facility for bellowed sealed valves including seal replacement and
bellow assemble replacement.
-
Full repair facility for sealing and non sealing throttle valves.
-
Leak detection capability to better than 10-10 mbar Ls-1 of
He.
Residual Gas Analysis
-
Full repair, test and calibration of the MKS-Spectra series quadrupole gas
analyser and the PAS series analytical systems, including ion source
replacement, detector replacement (faraday or electron multiplier) and full
repair of electronic control unit.
-
Partial pressure and total pressure calibration using spinning rotor gauge
technology and precise mixture calibration gases.
-
Leak detection capability to better than 10-10 mbar Ls-1
of He.
-
On site service and support capability for gas analyser products.
© 2009 by MKS Instruments